(I use a similar idea on BrundleFab, and I don't lose any powder over the sides).įinished objects have a weak green strength, but I leave them in the bed for ~4 hours, then gross depowder, then cook them in a 80C oven for 2 hours (to fully dry), then (since it's ZP150 powder) lightly spray the surface with Epson salt water (70ml epson salt by volume, then add water to make 160ml total, fully dissolve), let cure for another 2 hours in the 80C oven, then paint, and seal (I'm using clear nail polish for small objects, I have no idea what I'm going to use for large ones). If Z-corp had lathed in a 2mm x 5mm deep notch into the spreader, they could have eliminated the need for the snowplows, and the mess of powder on each side of the print box. I'm thinking about 3D-printing some less-terrible replacements. Check printing software allows individuals and companies to create, print, and mail physical checks or send digital checks without requiring a traditional checkbook or pre-printed checks from the. The 'snowplows' on the sides are held on to the side of the bin by (pretty weak) magnets, and I think they are too short to do a good job. There is no metal scraper, only the roller. Juli 2016 zuletzt geändert durch Bekanntmachung vom 20. (At a 2x slow-mo, I counted 2 revolutions per second, so that's about 4 real revolutions per second, or 240 RPM, calling it 250 RPM) Richtlinie zum Software-Sprint Förderung von Open Source Entwicklerinnen und Entwicklern. There is a rolling spreader, 19mm in diameter, that spins at approx 250 RPM.
0 Comments
Leave a Reply. |